Dell MXL 10GbE - Snmp-Server Enable Traps

Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
snmp-server enable traps
Enable SNMP traps.
Syntax
snmp-server enable traps [notification-type] [notification-
option]
To disable traps, use the no snmp-server enable traps [notification-
type
] [notification-option] command.
Parameters
notification-
type
Enter the type of notification from the following list:
• ecfm — Notification of changes to ECFM.
• entity — Notification of changes to entity.
• envmon — For Dell Networking device notifications when
an environmental threshold is exceeded.
• eoam — Notification of changes to the EOAM state.
• ets — Notification of changes to the ets traps.
• fips — Notification of changes to the FIP snooping
state.
• lacp — Notification of changes.
• pfc — Notification of changes to pfc traps.
• snmp — Notification of RFC 1157 traps.
• stp — Notification of a state change in the spanning tree
protocol (RFC 1493).
• vrrp — Notification of a state change in a VRRP group.
• xstp — Notification of a state change in MSTP (802.1s),
RSTP (802.1w), and PVST+.
notification-
option
For the envmon notification-type, enter one of the following
optional parameters:
• temperature
For the snmp notification-type, enter one of the following
optional parameters:
• authentication
• coldstart
Simple Network Management Protocol (SNMP) and Syslog
1227