intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled.
Syntax
intf-type cr4 autoneg
If you configure intf-type cr4 autoneg, use the no intf-type cr4
autoneg command to set the interface type as cr4 with autonegotiation disabled.
Defaults Not configured
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you configure interface type as CR4 with auto-negotiation enabled, also
configure CR4 with auto-negotiation. Many DAC cable link issues are resolved by
setting the interface type as CR4.
Related
Commands
interface — configures a physical interface.
interface port-channel — configures a port channel group.
keepalive
Send keepalive packets periodically to keep an interface alive when it is not transmitting data.
Syntax
keepalive [seconds]
To stop sending keepalive packets, use the no keepalive command.
Parameters
seconds (OPTIONAL) For interfaces with PPP encapsulation enabled,
enter the number of seconds between keepalive packets.
The range is from 0 to 23767. The default is 10 seconds.
Defaults Enabled.
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
1472
PMUX Mode of the MXL 10/40GbE Switch I/O Module
To Next Page
Loading...
