Dell MXL 10GbE - Ip Msdp Log-Adjacency-Changes

Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.)
list name Enter the keywords list name and specify a standard
access list that contains the RP address that should be
treated as the default peer. If no access list is specified, then
all SAs from the peer are accepted.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If a list is not specified, all SA messages received from the default peer are
accepted. You can enter multiple default peer commands.
ip msdp log-adjacency-changes
Enable logging of MSDP adjacency changes.
Syntax
ip msdp log-adjacency-changes
To disable logging, use the no ip msdp log-adjacency-changes command.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
ip msdp mesh-group
To be a member of a mesh group, configure a peer.
Syntax
ip msdp mesh-group {name} {peer address}
To remove the peer from a mesh group, use the no ip msdp mesh-group
{name} {peer address} command.
Parameters
name Enter a string of up to 16 characters long for as the mesh
group name.
peer address Enter the peer address in a dotted decimal format (A.B.C.D.).
890
Multicast Source Discovery Protocol (MSDP)