Dell MXL 10GbE - Interface Managementethernet

Parameters
number Enter a number as the interface number. The range is from 0
to 16383.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf)#interface loopback 1655
Dell(conf-if-lo-1655)#
Related
Commands
interface — configures a physical interface.
interface null — configures a Null interface.
interface port-channel — configures a port channel.
interface vlan — configures a VLAN.
interface ManagementEthernet
Configure the Management port on the system.
Syntax
interface ManagementEthernet slot/port
Parameters
slot/port Enter the keyword ManagementEthernet, then the slot
number (0 or 1) and port number zero (0).
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). To assign an IP
address to the Management port, use the
ip address command.
Interfaces
563