Dell MXL 10GbE - Show Sflow

show sflow
Display the current sFlow configuration.
Syntax
show sflow [interface]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The dropEvent counter (sFlow samples dropped due to sub-sampling) shown in
the following example always displays a value of zero.
Example
Dell#show sflow
sFlow services are enabled
Egress Mangement Interface sFlow services are disabled
Global default sampling rate: 2048
Global default counter polling interval: 20
Global extended information enabled: none
0 collectors configured
0 UDP packets exported
0 UDP packets dropped
0 sFlow samples collected
stack-unit 0 Port set 0
Te 0/0: configured rate 256, actual rate 256
Dell#
Dell#show running-config sflow
!
sflow enable
sflow sample-rate 2048
Dell#show running-config interface tengigabitethernet 0/0
!
interface TenGigabitEthernet 0/0
no ip address
sflow enable
sflow sample-rate 256
no shutdown
1214
sFlow