disable
Disable the spanning tree protocol globally on the switch.
Syntax
disable
To enable Spanning Tree Protocol, use the no disable command.
Defaults Enabled (that is, the spanning tree protocol is disabled.)
Command
Modes
SPANNING TREE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
portfast bpdufilter default — enters SPANNING TREE mode.
forward-delay
The amount of time the interface waits in the Listening state and the Learning state before transitioning
to the Forwarding state.
Syntax
forward-delay seconds
To return to the default setting, use the no forward-delay command.
Parameters
seconds Enter the number of seconds that the system waits before
transitioning STP to the Forwarding state. The range is from
4 to 30. The default is 15 seconds.
Defaults 15 seconds
Command
Modes
SPANNING TREE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
max-age — changes the wait time before STP refreshes protocol configuration
information.
hello-time — changes the time interval between BPDUs.
1272
Spanning Tree Protocol (STP)
To Next Page
Loading...
