gvrp enable
Enable GVRP on physical interfaces and LAGs.
Syntax
gvrp enable
To disable GVRP on the interface, use the no gvrp enable command.
Defaults Disabled.
Command
Modes
CONFIGURATION-INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
disable — globally disables GVRP.
gvrp registration
Configure the GVRP register type.
Syntax
gvrp registration {fixed | normal | forbidden}
To return to the default, use the gvrp register normal command.
Parameters
fixed Enter the keyword fixed then the VLAN range in a comma-
separated VLAN ID set.
normal Enter the keyword normal then the VLAN range in a
comma-separated VLAN ID set. This setting is the default.
forbidden Enter the keyword forbidden then the VLAN range in a
comma-separated VLAN ID set.
Defaults normal
Command
Modes
CONFIGURATION-INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Fixed registration prevents an interface, configured using the command line, to
belong to a VLAN (static configuration) from being unconfigured when it receives a
Leave message. Therefore, Registration mode on that interface is fixed.
Normal registration is the default registration. The port’s membership in the VLAN
depends on GVRP. The interface becomes a member of a VLAN after learning
about the VLAN through GVRP. If the VLAN is removed from the port that sends
GVRP advertisements to this device, the port stops being a member of the VLAN.
GARP VLAN Registration (GVRP)
539
To Next Page
Loading...
