Dell MXL 10GbE - Ip Tacacs Source-Interface

Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ip tacacs source-interface
Specify an interface’s IP address as the source IP address for TACACS+ connections.
Syntax
ip tacacs source-interface interface
To delete a source interface, use the no ip tacacs source-interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16838.
• For the Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
tacacs-server host
Specify a TACACS+ host.
Syntax
tacacs-server host {hostname | ipv4-address} [port number]
[timeout seconds] [key key]
Parameters
hostname Enter the name of the TACACS+ server host.
ipv4-address Enter the IPv4 address (A.B.C.D) of the TACACS+ server host.
Security
1181