Parameters
vlan vlan-range Enter the keyword vlan then the VLAN numbers. The range
is from 1 to 4094.
bridge-priority
value
Enter the keywords bridge-priority then the bridge
priority value in increments of 4096. The range is from 0 to
61440. The default is
32768.
Defaults 32768
Command
Modes
CONFIGURATION (conf-pvst)
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
vlan forward-delay — changes the time interval before the system transitions to the
Forwarding state.
vlan hello-time — change the time interval between BPDUs.
vlan max-age — changes the time interval before PVST+ refreshes.
show spanning-tree pvst — displays the PVST+ configuration.
vlan forward-delay
Set the amount of time the interface waits in the Listening state and the Learning state before
transitioning to the Forwarding state.
Syntax
vlan vlan-id forward-delay seconds
To return to the default setting, use the no vlan forward-delay command.
Parameters
vlan vlan-range Enter the keyword vlan then the VLAN numbers. The range
is from 1 to 4094.
forward-delay
seconds
Enter the keywords forward-delay then the time interval,
in seconds, that the system waits before transitioning PVST+
to the forwarding state. The range is from 4 to 30 seconds.
The default is 15 seconds.
Defaults 15 seconds
Command
Modes
CONFIGURATION (conf-pvst)
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Per-VLAN Spanning Tree Plus (PVST+)
1069
To Next Page
Loading...
