disable
Disable the DHCP server.
Syntax
disable
DHCP Server is disabled by default. To enable the system to be a DHCP server, use
the no disable command.
Defaults Disabled
Command
Modes
DHCP
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
dns-server
Assign a DNS server to clients based on address pool.
Syntax
dns-server address [address2...address8]
Parameters
address Enter a list of DNS servers that may service clients on the
subnet. You may list up to eight servers, in order of
preference.
Defaults none
Command
Modes
DHCP <POOL>
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
domain-name
Assign a domain to clients based on the address pool.
Syntax
domain-name name
Parameters
name Give a name to the group of addresses in a pool.
Defaults none
Command
Modes
DHCP <POOL>
486
Dynamic Host Configuration Protocol (DHCP)
To Next Page
Loading...
