To delete an uplink-state group, enter the no uplink-state-group group-id
command.
To disable upstream-link tracking without deleting the uplink-state group, use the
no enable command in Uplink-State-Group Configuration mode.
Parameters
group-id Enter the ID number of an uplink-state group. The range is
from 1 to 16.
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module..
Usage
Information
After you enter the command, to assign upstream and downstream interfaces to
the group, enter Uplink-State-Group Configuration mode.
An uplink-state group is considered to be operationally up if at least one upstream
interface in the group is in the Link-Up state.
An uplink-state group is considered to be operationally down if no upstream
interfaces in the group are in the Link-Up state. No uplink-state tracking is
performed when a group is disabled or in an operationally down state.
Example
Dell(conf)#uplink-state-group 16
Dell(conf)#
02:23:17: %STKUNIT0-M:CP %IFMGR-5-ASTATE_UP: Changed uplink
state group Admin
state to up: Group 16
Related
Commands
• show running-config uplink-state-group — displays the current configuration
of one or more uplink-state groups.
• show uplink-state-group — displays the status information on a specified
uplink-state group or all groups.
upstream
Assign a port or port-channel to the uplink-state group as an upstream interface.
Syntax
upstream interface
To delete an uplink-state group, use the no upstream interface command.
Parameters
interface Enter one of the following interface types:
1320
Uplink Failure Detection (UFD)
To Next Page
Loading...
