%RPM:0:0 %CHMGR-2-LINECARDDOWN - Line card 3 down - IPC timeout
Dell#
show logging driverlog stack-unit
Display the driver log for the specified stack member.
Syntax
show logging driverlog stack-unit unit#
Parameters
stack-unit
unit#
Enter the keywords stack-unit followed by the stack
member ID of the switch for which you want to display the
driver log. The range is from 0 to 7.
defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Usage
Information
This command displays internal software driver information, which may be useful
during troubleshooting switch initialization errors, such as a downed Port-Pipe.
terminal monitor
Configure the Dell Networking OS to display messages on the monitor/terminal.
Syntax
terminal monitor
To return to default settings, use the terminal no monitor command.
defaults Disabled.
Command
Modes
• EXEC
• EXEC Privilege
1544
PMUX Mode of the MXL 10/40GbE Switch I/O Module
To Next Page
Loading...
