Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
An MSDP mesh group is a mechanism for reducing SA flooding, typically in an
intra-domain setting. When some subset of a domain’s MSDP speakers are fully
meshed, they can be configured into a mesh-group. If member X of a mesh-group
receives a SA message from an MSDP peer that is also a member of the mesh-
group, member X accepts the SA message and forwards it to all of its peers that are
not part of the mesh-group. However, member X cannot forward the SA message
to other members of the mesh-group.
ip msdp originator-id
Configure the MSDP Originator ID.
Syntax
ip msdp originator-id {interface}
To remove the originator-id, use the no ip msdp originator-id
{interface} command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a SONET interface, enter the keywords sonet then
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Multicast Source Discovery Protocol (MSDP)
891
To Next Page
Loading...
