Dell MXL 10GbE - Show Config

Parameters
sequence-
number
Enter a number. The range is from 1 to 4294967294.
deny Enter the keyword deny to configure a filter to drop packets
meeting this condition..
permit Enter the keyword permit to configure a filter to forward
packets meeting this condition.
any (OPTIONAL) Enter the keyword any to match any packets.
ip-prefix /nn (OPTIONAL) Specify an IP prefix in the network/length
format. For example, 35.0.0.0/8 means match the first 8 bits
of address 35.0.0.0.
ge min-prefix-
length
(OPTIONAL) Enter the keyword ge and then enter the
minimum prefix length, which is a number from zero (0) to
32.
le max-prefix-
length
(OPTIONAL) Enter the keyword le and then enter the
maximum prefix length, which is a number from zero (0) to
32.
bitmask
number
Enter the keyword bitmask then enter a bit mask number in
dotted decimal format.
Defaults Not configured.
Command
Modes
PREFIX-LIST
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you do not use the ge or le options, only packets with an exact match to the
prefix are filtered.
Related
Commands
deny — configures a filter to drop packets.
permit — configures a filter to pass packets.
show config
Display the current PREFIX-LIST configurations.
Syntax
show config
Command
Modes
PREFIX-LIST
198
Access Control Lists (ACL)