Dell MXL 10GbE - Network Backdoor

Usage
Information
The system software resolves the network address the network command
configures with the routes in the main routing table to ensure that the networks are
reachable using non-BGP routes and non-default routes.
Related
Commands
redistribute — redistributes routes into BGP.
network backdoor
Specify this IGP route as the preferred route.
Syntax
network ip-address mask backdoor
To remove a network, use the no network ip-address mask backdoor
command.
Parameters
ip-address Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length
format (for example, /24).
The mask appears in command outputs in dotted decimal
format (A.B.C.D).
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Although the system does not generate a route due to the backdoor config, there
is an option for injecting/sourcing a local route in the presence of network
backdoor config on a learned route.
redistribute
Redistribute routes into BGP.
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static}
command.
Parameters
connected Enter the keyword connected to redistribute routes from
physically connected interfaces.
358
Border Gateway Protocol IPv4 (BGPv4)