Dell MXL 10GbE - Area Nssa

Parameters
area-id Specify the OSPF area in dotted decimal format (A.B.C.D.) or
enter a number from zero (0) to 65535.
cost Specifies the stub area’s advertised external route metric. The
range is from zero (0) to 65535.
Defaults cost = 1; no areas are configured.
Command
Modes
ROUTER OSPF
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
In the Dell Networking operating software, cost is defined as reference bandwidth.
Related
Commands
area stub — creates a stub area.
area nssa
Specify an area as a not so stubby area (NSSA).
Syntax
area area-id nssa [default-information-originate] [no-
redistribution] [no-summary]
To delete an NSSA, use the no area area-id nssa command.
Parameters
area-id Specify the OSPF area in dotted decimal format (A.B.C.D.) or
enter a number from zero (0) to 65535.
no-
redistribution
(OPTIONAL) Specify that the redistribute command does
not distribute routes into the NSSA. Only use this command
in an NSSA area border router (ABR).
default-
information-
originate
(OPTIONAL) Allows external routing information to be
imported into the NSSA by using Type 7 default.
no-summary (OPTIONAL) Specify that no summary LSAs should be sent
into the NSSA.
Defaults Not configured.
Command
Modes
ROUTER OSPF
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Open Shortest Path First (OSPFv2 and OSPFv3)
925