Dell MXL 10GbE - Debug Uplink-State-Group

Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.4.2.3 Introduced on the S-Series S50.
Related
Commands
• downstream — assigns a port or port-channel to the uplink-state group as a
downstream interface.
• uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
debug uplink-state-group
Enable debug messages for events related to a specified uplink-state group or all groups.
Syntax
debug uplink-state-group [group-id]
To turn off debugging event messages, enter the no debug uplink-state-
group [group-id] command.
Parameters
group-id Enables debugging on the specified uplink-state group. The
valid group-id values are from 1 to 16.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0
Introduced on the S4820T.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
1521