Dell MXL 10GbE - Member-Vlan

• Fast Ethernet interface: enter the keyword
FastEthernet then the slot/port information.
• Port Channel interface: enter the keyword port-
channel then a number. The range is from 1 to 128.
• 10-Gigabit Ethernet interface: enter the keyword
TenGigabitEthernet then the slot/port information
• 40-Gigabit Ethernet interface: enter the keyword
fortyGigE then the slot/port information
secondary
interface
Enter the keyword secondary to configure the secondary
interface then one of the following interfaces and slot/port
information:
• Fast Ethernet interface: enter the keyword
FastEthernet then the slot/port information.
• Port Channel interface: enter the keyword port-
channel
then a number. The range is from 1 to 128.
• 10-Gigabit Ethernet interface: enter the keyword
TenGigabitEthernet then the slot/port information
• 40-Gigabit Ethernet interface: enter the keyword
fortyGigE then the slot/port information
control-vlan
vlan-id
Enter the keyword control-vlan then the VLAN ID. The
range is from 1 to 4094.
Defaults none
Command
Modes
CONFIGURATION (conf-frrp)
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command causes the Ring Manager to take ownership of the two ports after
IFM validates the configuration. Ownership is relinquished for a port only when the
interface does not play a part in any control VLAN, that is, the interface does not
belong to any ring.
Related
Commands
show frrp — displays the resilient ring protocol configuration information.
member-vlan
Specify the member VLAN identification numbers.
Syntax
member-vlan {vlan-range}
To return to the default, use the no member-vlan [vlan-range] command.
530
Force10 Resilient Ring Protocol (FRRP)