Dell MXL 10GbE - Redistribute Bgp

route-map
map-name
(OPTIONAL) If you do not enter the route-map argument, all
routes are redistributed. If a map-name value is not specified,
no routers are imported.
Defaults
• metric metric-value = 0
• metric-type= internal; level-2
Command
Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To redistribute a default route (0.0.0.0/0), configure the default-information
originate command.
Changing or disabling a keyword in this command does not affect the state of the
other command keywords.
When an LSP with an internal metric is received, the system considers the route
cost while considering the advertised cost to reach the destination.
Redistributed routing information is filtered with the distribute-list out
command to ensure that the routes are properly are passed to the receiving
routing protocol.
How a metric value assigned to a redistributed route is advertised depends on how
on the configuration of the metric-style command. If the metric-style
command is set for Narrow or Transition mode and the metric value in the
redistribute command is set to a number higher than 63, the metric value
advertised in LSPs is 63. If the metric-style command is set for Wide mode, the
metric value in the redistribute command is advertised.
Related
Commands
• default-information originate — generates a default route for the IS-IS domain.
• distribute-list out — suppresses networks from being advertised in updates. This
command filters redistributed routing information.
redistribute bgp
Redistribute routing information from a BGP process. (New command in Release 6.3.1.)
Syntax
redistribute bgp AS number [level-1| level-1-2 | level-2]
[metric metric-value] [metric-type {external| internal}]
[route-map map-name]
Intermediate System to Intermediate System (IS-IS)
825