Dell MXL 10GbE - Max-Age

max-age
To maintain configuration information before refreshing that information, set the time interval for the
RSTP bridge.
Syntax
max-age seconds
To return to the default values, use the no max-age command.
Parameters
max-age Enter a number of seconds that the waits before refreshing
configuration information. The range is from 6 to 40
seconds. The default is 20 seconds.
Defaults 20 seconds
Command
Modes
CONFIGURATION RSTP (conf-rstp)
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
forward-delay — changes the wait time before RSTP transitions to the Forwarding
state.
hello-time — changes the time interval between BPDUs.
edge-port bpdufilter default
To filter transmission of BPDU on port fast enabled interfaces, enable BPDU Filter globally.
Syntax
edge-port bpdufilter default
To disable global bpdu filter default, use the no edge-port bpdufilter
default
command.
Parameters
priority-value Enter a number as the bridge priority value in increments of
4096. The range is from 0 to 61440. The default is 32768.
Defaults Disabled
Command
Modes
CONFIGURATION (conf-rstp)
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
1146
Rapid Spanning Tree Protocol (RSTP)