Dell MXL 10GbE - Buffer (Configuration)

buffer (Configuration)
Apply a buffer profile to all Field or Switch Fabric processors in a port-pipe.
Syntax
buffer [csf | fp-uplink] port-set port-pipe buffer-policy
buffer-profile
Parameters
csf Enter the keyword csf to apply a buffer profile to all Switch
Fabric processors in a port-pipe.
fp-uplink Enter the keyword fp-uplink to apply a buffer profile to all
Field Processors in a a port-pipe.
port-set port-
pipe
Enter the keywords port-set then the port-pipe number.
The range is 0 to 1.
buffer-policy
buffer-profile
Enter the keywords buffer-policy then the name of a
buffer profile you created.
Defaults none
Command
Modes
BUFFER PROFILE
Command
History
Version
8.3.16.10
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you attempt to apply a buffer profile to a non-existent port-pipe, the Dell
Networking OS displays the following message. However, the configuration still
appears in the running-config.
%DIFFSERV-2-DSA_BUFF_CARVING_INVALID_PORT_SET: Invalid FP port-
set 2 for stack–unit 2. Valid range of port-set is <0-1>
When you remove a buffer-profile using the no buffer-profile [fp | csf]
command from CONFIGURATION mode, the buffer-profile name still appears in
the output of show buffer-profile [detail | summary]. After a line card
reset, the buffer profile correctly returns to the default values, but the profile name
remains. Remove it from the show buffer-profile [detail | summary]
command output by entering no buffer [fp-uplink | csf] buffer-
policy from CONFIGURATION mode and no buffer-policy from INTERFACE
mode.
Related
Commands
buffer-profile (Configuration) — creates a buffer profile that can be applied to an
interface.
468
Debugging and Diagnostics