• ^ = (caret) the beginning of the input string. If the caret is
used at the beginning of a sequence or range, it matches
on everything BUT the characters specified.
• $ = (dollar sign) the end of the output string.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
timers bgp
Allows you to adjust the BGP network timers for all neighbors.
Syntax
timers bgp keepalive holdtimer
To return to the default values, use the no timers bgp command.
Parameters
keepalive Enter the time interval (in seconds) between which the
system sends keepalive messages. The range is from 1 to
65535. The default is 60 seconds.
holdtimer Enter the time interval (in seconds) that the the system waits
since the last keepalive message before declaring a BGP peer
dead. The range is from 3 to 65535. The default is 180
seconds.
Defaults
• keepalive = 60 seconds
• holdtimer = 180 seconds
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
neighbor timers — adjusts BGP timers for a specific peer or peer group.
758
IPv6 Border Gateway Protocol (IPv6 BGP)
To Next Page
Loading...
