Dell MXL 10GbE - Protocol-Tunnel Destination-Mac

Related
Command
show protocol-tunnel — displays tunneling information for all VLANs.
protocol-tunnel destination-mac
Overwrite the BPDU destination MAC address with a specific value.
Syntax
protocol-tunnel destination-mac xstp address
Parameters
stp Change the default destination MAC address used for L2PT
to another value.
Defaults The default destination MAC is 01:01:e8:00:00:00.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you enable VLAN-Stacking, no protocol packets are tunneled.
Related
Command
show protocol-tunnel — displays tunneling information for all VLANs.
protocol-tunnel enable
Enable protocol tunneling globally on the system.
Syntax
protocol-tunnel enable
To disable protocol tunneling, use the no protocol-tunnel enable command.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The system must have the default CAM profile with the default microcode before
you enable L2PT.
1218
Service Provider Bridging