Dell MXL 10GbE - Spanning-Tree

BPDU (MRecords): sent 21, received 9
The port is not in the Edge port mode
Usage
Information
The following describes the show spanning-tree msti 5 guard command
shown in the following example.
Field Description
Interface Name MSTP interface.
Instance MSTP instance.
Sts Port state: root-inconsistent (INCON Root), forwarding
(FWD), listening (LIS), blocking (BLK), or shut down (EDS
Shut).
Guard Type Type of STP guard configured (Root, Loop, or BPDU guard).
Example
(Guard)
Dell#show spanning-tree msti 0 guard
Executing IEEE compatible Spanning Tree Protocol
Bpdu filter disabled globally
Interface
Name Instance Sts Guard type Bpdu Filter
--------- -------- --------- ---------- -----------
Te 0/41 0 FWD None No
Te 0/42 0 FWD None No
Te 0/43 0 FWD None No
spanning-tree
Enable the multiple spanning tree protocol on the interface.
Syntax
spanning-tree
To disable the multiple spanning tree protocol on the interface, use the no
spanning-tree
command.
Parameters
spanning-tree Enter the keywords spanning-tree to enable the MSTP on
the interface.
Defaults Enable.
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
908
Multiple Spanning Tree Protocol (MSTP)