Dell MXL 10GbE - Show Qos Policy-Map-Input

detail interface To view a policy map interface in detail, enter the keyword
detail and optionally one of the following keywords and
slot/port or number information:
• For a 40 Gigabit Ethernet interface, enter the keyword
FortyGigabitEthernet then the slot/port information.
• For a 10 Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example (IPv4)
Dell#show qos policy-map detail tengigabitethernet 0/0
Interface tenGigabitEthernet 4/1
Policy-map-input policy
Trust diffserv
Queue# Class-map-name Qos-policy-name
0 - q0
1 CM1 q1
2 CM2 q2
3 CM3 q3
Example
(Summary IPv4)
Dell#sho qos policy-map summary
Interface policy-map-input policy-map-output
Gi 4/1 PM1 -
Te 4/2 PM2 PMOut
Dell#
show qos policy-map-input
View the input QoS policy map details.
Syntax
show qos policy-map-input [policy-map-name] [class class-map-
name] [qos-policy-input qos-policy-name]
Parameters
policy-map-
name
Enter the policy map name.
Quality of Service (QoS)
1097