Dell MXL 10GbE - Fip-Snooping Enable

Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
fip-snooping enable
Enable FIP snooping on all VLANs or on a specified VLAN.
Syntax
fip-snooping enable
To disable the FIP snooping feature on all or a specified VLAN, use the no fip-
snooping enable
command.
Defaults FIP snooping is disabled on all VLANs.
Command
Modes
• CONFIGURATION
• VLAN INTERFACE
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The maximum number of FCFs supported per FIP snooping-enabled VLAN is four.
The maximum number of FIP snooping sessions supported per ENode server is 16.
fip-snooping fc-map
Configure the FC-MAP value FIP snooping uses on all VLANs.
Syntax
fip-snooping fc-map fc-map-value
To return the configured FM-MAP value to the default value, use the no fip-
snooping fc-map command.
Parameters
fc-map-value Enter the FC-MAP value FIP snooping uses. The range is
from 0EFC00 to 0EFCFF.
Defaults 0x0EFC00
Command
Modes
• CONFIGURATION
• VLAN INTERFACE
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
1458
PMUX Mode of the MXL 10/40GbE Switch I/O Module