Dell MXL 10GbE - Show Qos Class-Map

Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
After the IP DSCP bit is set, other QoS services can then operate on the bit settings.
show qos class-map
View the current class map information.
Syntax
show qos class-map [class-name]
Parameters
class-name (Optional) Enter the name of a configured class map.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show qos class-map
Class-map match-any CM
Match ip access-group ACL
Related
Commands
class-map — identifies the class map.
show qos policy-map
View the QoS policy map information.
Syntax
show qos policy-map {summary [interface] | detail [interface]}
Parameters
summary
interface
To view a policy map interface summary, enter the keyword
summary and optionally one of the following keywords and
slot/port or number information:
• For a 40 Gigabit Ethernet interface, enter the keyword
FortyGigabitEthernet then the slot/port information.
• For a 10 Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
1096
Quality of Service (QoS)