Dell MXL 10GbE - Page 1095

Parameters
queue-id Enter the value used to identify a queue. The range is from 0
to 3 (four queues per interface; four queues are reserved for
control traffic).
class-map
class-map-
name
(OPTIONAL) Enter the keyword class-map then the class
map name assigned to the queue in character format (32
character maximum).
NOTE: This option is available under policy-map-
input
only.
qos-policy
qos-policy-
name
(OPTIONAL) Enter the keywords qos-policy then the QoS
policy name assigned to the queue in text format (32
characters maximum). This specifies the input QoS policy
assigned to the queue under
policy-map-input and
output QoS policy under policy-map-output context.
Defaults none
Command
Modes
CONFIGURATION (conf-policy-map-in and conf-policy-map-out)
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
There are four queues per interface on the MXL switch. This command assigns a
class map or QoS policy to different queues.
Related
Commands
service-policy output — applies an output policy map to the selected interface.
set
Mark outgoing traffic with a differentiated service code point (DSCP) or dot1p value.
Syntax
set {ip-dscp value | mac-dot1p value}
Parameters
ip-dscp value (OPTIONAL) Enter the keywords ip-dscp then the IP DSCP
value. The range is from 0 to 63.
mac-dot1p
value
Enter the keywords mac-dot1p then the dot1p value. The
range is from 0 to 7.
Defaults none
Command
Modes
CONFIGURATION (conf-qos-policy-in)
Quality of Service (QoS)
1095