Dell MXL 10GbE - Ipv6 PIM-Sparse Mode Commands

IPv6 PIM-Sparse Mode Commands
The following describes the IPv6 PIM-sparse mode (PIM-SM) commands.
ipv6 pim bsr-border
Define the border of PIM domain by filtering inbound and outbound PIM-BSR messages per interface.
Syntax
ipv6 pim bsr-border
Defaults Disabled.
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command is applied to the subsequent PIM-BSR messages. Existing BSR
advertisements are cleaned up by time-out.
ipv6 pim bsr-candidate
Configure the router as a bootstrap (BSR) candidate.
Syntax
ipv6 pim bsr-candidate interface [hash-mask-length] [priority]
To disable the bootstrap candidate, use the no ipv6 pim bsr-candidate
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
hash-mask-
length
(OPTIONAL) Enter the hash mask length for RP selection.
The range is from 0 to 128. The default is 126.
priority (OPTIONAL) Enter the priority value for Bootstrap election
process. The range is from 0 to 255. The default is 0.
1034
PIM-Sparse Mode (PIM-SM)