Dell MXL 10GbE - Service-Policy Output

Related
Commands
policy-map-input — creates an input policy map.
service-policy output
Apply an output policy map to the selected interface.
Syntax
service-policy output policy-map-name
To remove the output policy map from the interface, use the no service-
policy output policy-map-name command.
Parameters
policy-map-
name
Enter the name for the policy map in character format (16
characters maximum). You can identify an existing policy
map or name one that does not yet exist.
Defaults none
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
A single policy-map can be attached to one or more interfaces to specify the
service-policy for those interfaces. A policy map attached to an interface can be
modified.
Related
Commands
policy-map-output — creates an output policy map.
service-queue
Assign a class map and QoS policy to different queues.
Syntax
service-queue queue-id [class-map class-map-name] [qos-policy
qos-policy-name]
To remove the queue assignment, use the no service-queue queue-id
[class-map class-map-name] [qos-policy qos-policy-name]
command.
1094
Quality of Service (QoS)