Dell MXL 10GbE - Arp Inspection-Trust

arp inspection-trust
Specify a port as trusted so that ARP frames are not validated against the binding table.
Syntax
arp inspection-trust
Defaults Disabled
Command
Modes
• INTERFACE
• INTERFACE PORT-CHANNEL
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
arp inspection — enables dynamic ARP inspection on a VLAN.
clear ip dhcp snooping
Clear the DHCP binding table.
Syntax
clear ip dhcp snooping binding
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
show ip dhcp snooping — displays the contents of the DHCP binding table.
ip dhcp snooping
Enable DHCP snooping globally.
Syntax
[no] ip dhcp snooping
Defaults Disabled
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Dynamic Host Configuration Protocol (DHCP)
497