peer-group-
name
Enter the name of the peer group.
prefix-list-
name
Enter the name of an established prefix list. If the prefix list is
not configured, the default is permit (to allow all routes).
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.
Defaults Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
neighbor filter-list — assigns a AS-PATH list to a neighbor or peer group.
neighbor route-map — assigns a route map to a neighbor or peer group.
neighbor ebgp-multihop
Attempt and accept BGP connections to external peers on networks that are not directly connected.
Syntax
neighbor {ipv6-address | peer-group-name} ebgp-multihop [ttl]
To disallow and disconnect connections, use the no neighbor {ipv6-address
| peer-group-name} ebgp-multihop [ttl] command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group.
ttl (OPTIONAL) Enter the number of hops as the time to live (ttl)
value. The range is from 1 to 255. The default is 255.
Defaults Disabled.
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
IPv6 Border Gateway Protocol (IPv6 BGP)
725
To Next Page
Loading...
