Dell MXL 10GbE - Set Metric

Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
set metric — specify the metric value assigned to redistributed routes.
set metric-type — specify the metric type assigned to redistributed routes.
set tag — specify the tag assigned to redistributed routes.
set metric
To assign a new metric to redistributed routes, configure a filter.
Syntax
set metric [+ | -] metric-value
To delete a setting, use the no set metric command.
Parameters
+ (OPTIONAL) Enter + to add a metric-value to the
redistributed routes.
- (OPTIONAL) Enter - to subtract a metric-value from the
redistributed routes.
metric-value Enter a number as the new metric value. The range is from
zero (0) to 4294967295.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
set automatic-tag — computes the tag value of the route.
set metric-type — specifies the route type assigned to redistributed routes.
set tag — specifies the tag assigned to redistributed routes.
208
Access Control Lists (ACL)