Dell MXL 10GbE - Show Qos Dcb-Output

Usage
Information
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
Example
Dell(conf)# show qos dcb-input
dcb-input pfc-profile
pfc link-delay 32
pfc priority 0-1
dcb-input pfc-profile1
no pfc mode on
pfc priority 6-7
show qos dcb-output
Displays the ETS configuration in a DCB output policy.
Syntax
show qos dcb-output [ets-profile]
Parameters
[ets-profile] Enter the ETS profile.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
Example
Dell# show qos dcb-output
dcb-output ets
priority-group san qos-policy san
priority-group ipc qos-policy ipc
priority-group lan qos-policy lan
Data Center Bridging (DCB)
451