Dell MXL 10GbE - Redistribute

Defaults Not configured.
Command
Modes
ROUTER ISIS
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Although the passive interface does not send nor receive routing updates, the
network on that interface is still included in the IS-IS updates sent using other
interfaces.
redistribute
Redistribute routes from one routing domain to another routing domain.
Syntax
redistribute {static | connected | rip} [level-1 | level-1-2 |
level-2] [metric metric-value] [metric-type {external |
internal}] [route-map map-name]
To end redistribution or disable any of the specified keywords, use the no
redistribute {static | connected | rip} [metric metric-value]
[metric-type {external | internal}] [level-1 | level-1-2 |
level-2] [route-map map-name] command.
Parameters
connected Enter the keyword connected to redistribute active routes
into IS-IS.
rip Enter the keyword rip to redistribute RIP routes into IS-IS.
static Enter the keyword static to redistribute user-configured
routes into IS-IS.
metric metric-
value
(OPTIONAL) Assign a value to the redistributed route. The
range is from 0 to 16777215. The default is 0. Use a value that
is consistent with the destination protocol.
metric-type
{external |
internal}
(OPTIONAL) The external link type associated with the
default route advertised into a routing domain. Specify one
of the following:
• external
• internal
level-1 (OPTIONAL) Routes are independently redistributed into IS-
IS as Level 1 routes.
level-1-2 (OPTIONAL) Routes are independently redistributed into IS-
IS as Level-1-2 routes.
level-2 (OPTIONAL) Routes are independently redistributed into IS-
IS as Level 2 routes. This setting is the default.
824
Intermediate System to Intermediate System (IS-IS)