Dell MXL 10GbE - Snmp-Server Packetsize

snmp-server packetsize
Set the largest SNMP packet size permitted. Wen the SNMP server is receiving a request or generating a
reply, use the snmp-server packetsize global configuration command.
Syntax
snmp-server packetsize byte-count
Parameters
byte-count Enter one of the following values 8, 16, 24 or 32. Packet sizes
are 8000 bytes, 16000 bytes, 32000 bytes, and 64000 bytes.
Defaults 8
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
snmp-server trap-source
Configure a specific interface as the source for SNMP traffic.
Syntax
snmp-server trap-source interface
To disable sending traps out a specific interface, use the no snmp trap-source
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults The IP address assigned to the management interface is the default.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To enable this snmp-server trap-source command, configure an IP address
on the interface and enable the interface configured as an SNMP trap source.
1234
Simple Network Management Protocol (SNMP) and Syslog