Dell MXL 10GbE - Show Frrp

Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command places you into the resilient ring protocol. After executing this
command, the command line prompt changes to conf-frrp.
show frrp
Display the resilient ring protocol configuration.
Syntax
show frrp [ring-id [summary]] | [summary]
Parameters
ring-id Enter the ring identification number. The range is from 1 to
255
summary (OPTIONAL) Enter the keyword summary to view just a
summarized version of the Ring configuration.
Defaults none
Command
Modes
EXEC
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Executing this command without the optional ring-id command clears the
statistics counters on all the available rings. The system requires a command line
confirmation before the command executes. This command clears the following
counters:
• hello Rx and Tx counters
• Topology change Rx and Tx counters
• The number of state change counters
Example
(Summary)
Dell#show frrp summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
----------------------------------------------
2 UP Master 2 11-20, 25,27-30
31 UP Transit 31 40-41
50 Down Transit 50 32
Dell#
Example (1)
Dell#show frrp 1
Ring protocol 1 is in Master mode
Ring Protocol Interface:
Primary : GigabitEthernet 0/16 State: Forwarding
532
Force10 Resilient Ring Protocol (FRRP)