Dell MXL 10GbE - Domain-Password

To return to the default, use the no distribute-list redistributed-
override in command.
Defaults none
Command
Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you execute this command, IS-IS does not download the route to the
routing table if the same route was redistributed into IS-IS routing protocol on the
same router.
domain-password
Set the authentication password for a routing domain.
Syntax
domain-password [hmac-md5 | encryption-type] password
To disable the password, use the no domain-password command.
Parameters
hmac-md5 (OPTIONAL) Enter the keywords hmac-md5 to encrypt the
password using MD5.
encryption-
type
(OPTIONAL) Enter 7 to encrypt the password using DES.
password Enter an alphanumeric string up to 16 characters long. If you
do not specify an encryption type or hmac-md5
keywords, the password is processed as plain text which
provides limited security.
Defaults No default password.
Command
Modes
ROUTER ISIS
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The domain password is inserted in Level 2 link state PDUs (LSPs), complete
sequence number PDUs (CSNPs), and partial sequence number PDUs (PSNPs).
Related
Commands
• area-password — configures an IS-IS area authentication password.
• isis priority — configures the authentication password for an interface.
Intermediate System to Intermediate System (IS-IS)
803