Dell MXL 10GbE - Speed (for 1000;10000;Auto Interfaces)

Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The shutdown command marks a physical interface as unavailable for traffic. To
discover if an interface is disabled, use the
show ip interface brief
command. Disabled interfaces are listed as down.
Disabling a VLAN or a port channel causes different behavior. When you disable a
VLAN, the Layer 3 functions within that VLAN are disabled. Layer 2 traffic continues
to flow. Entering the shutdown command on a port channel disables all traffic on
the port channel and the individual interfaces within the port channel. To enable a
port channel, enter no shutdown on the port channel interface and at least one
interface within that port channel.
The shutdown and description commands are the only commands that you
can configure on an interface that is a member of a port channel.
Related
Commands
interface port-channel — creates a port channel interface.
interface vlan — creates a VLAN.
show ip interface — displays the interface routing status. Add the keyword brief
to display a table of interfaces and their status.
speed (for 1000/10000/auto interfaces)
Set the speed for 1000/10000 Base-T Ethernet interfaces. Set both sides of a link to the same speed
(1000/10000) or to auto or the link may not come up.
Syntax
speed {1000 | 10000 | auto}
To return to the default setting, use the no speed {1000 | 10000 | auto}
command.
Parameters
1000 Enter the keyword 1000 to set the interface’s speed to 1000
Mb/s.
10000 Enter the keyword 10000 to set the interface’s speed to
10000 Mb/s. Auto-negotiation is enabled. For more
information, refer to
negotiation auto.
auto Enter the keyword auto to set the interface to auto-
negotiate its speed. Auto-negotiation is enabled. For more
information, refer to
negotiation auto.
Interfaces
597