Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you have exhausted all the sequence numbers, this feature permits re-
assigning a new sequence number to entries of an existing prefix list.
Related
Commands
seq — Assigns a sequence number to a deny or permit filter in an IP access list
while creating the filter.
show config
Display the current ACL configuration.
Syntax
show config
Command
Modes
• CONFIGURATION-IP ACCESS-LIST-STANDARD
• CONFIGURATION-IP ACCESS-LIST-EXTENDED
• CONFIGURATION-MAC ACCESS LIST-STANDARD
• CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(config-std-nacl)#show conf
!
ip access-list standard test
remark 5 Permit traffic from XYZ Inc.
seq 5 permit 1.1.1.0/24 count
remark 10 Deny traffic from ABC
seq 10 deny 2.1.1.0/24 count
Dell(config-std-nacl)#
Common IP ACL Commands
The following commands are available within both IP ACL modes (Standard and Extended) and do not
have mode-specific options. When an ACL is created without a rule and then is applied to an interface,
ACL behavior reflects an implicit permit.
The MXL 10/40GbE Switch IO Module platform supports both Ingress and Egress IP ACLs.
Access Control Lists (ACL)
143
To Next Page
Loading...
