Dell MXL 10GbE - Redistribute Ospf

redistribute ospf
Redistribute routing information from an OSPF process.
Syntax
redistribute ospf process-id [match external {1 | 2} | match
internal | metric metric-value] [route-map map-name]
To disable redistribution, use the no redistribute ospf process-id [match
external {1 | 2} | match internal | metric metric-value]
[route-map map-name] command.
Parameters
process-id Enter a number that corresponds to the OSPF process ID to
redistribute. The range is from 1 to 65355.
match external
{1 | 2}
(OPTIONAL) Enter the keywords match external then the
numbers 1 or 2 to indicated that external 1 routes or external
2 routes should be redistributed.
match internal (OPTIONAL) Enter the keywords match internal to
indicate that internal routes should be redistributed.
metric metric-
value
(OPTIONAL) Enter the keyword metric then a number as
the metric value. The range is from 0 to 16.
route-map
map-name
(OPTIONAL) Enter the keywords route-map then the name
of a configured route map.
Defaults Not configured.
Command
Modes
ROUTER RIP
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
router rip
To configure and enable RIP, enter ROUTER RIP mode.
Syntax
router rip
To disable RIP, use the no router rip command.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Routing Information Protocol (RIP)
1125