resequence access-list
Re-assign sequence numbers to entries of an existing access-list.
Syntax
resequence access-list {ipv4 | mac} {access-list-name
StartingSeqNum Step-to-Increment}
Parameters
ipv4 | mac Enter the keyword ipv4 or mac to identify the access list
type to resequence.
access-list-
name
Enter the name of a configured IP access list.
StartingSeqNu
m
Enter the starting sequence number to resequence. The
range is from 0 to 4294967290.
Step-to-
Increment
Enter the step to increment the sequence number. The
range is from 1 to 4294967290.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you have exhausted all the sequence numbers, this feature permits re-
assigning a new sequence number to entries of an existing access-list.
Related
Commands
resequence prefix-list ipv4 — resequences a prefix list.
resequence prefix-list ipv4
Re-assign sequence numbers to entries of an existing prefix list.
Syntax
resequence prefix-list ipv4 {prefix-list-name StartingSeqNum
Step-to-increment}
Parameters
prefix-list-
name
Enter the name of the configured prefix list, up to 140
characters long.
StartingSeqNu
m
Enter the starting sequence number to resequence. The
range is from 0 to 65535.
Step-to-
Increment
Enter the step to increment the sequence number. The
range is from 1 to 65535.
142
Access Control Lists (ACL)
To Next Page
Loading...
