Dell MXL 10GbE - Show Monitor Session

show monitor session
Display the monitor information of a particular session or all sessions.
Syntax
show monitor session {session-ID}
To display monitoring information for all sessions, use the show monitor
session command.
Parameters
session-ID (OPTIONAL) Enter a session identification number. The range
is from 0 to 65535.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.4.0.0 Added support for the RPM / ERPM.
Version 8.3.16.1 Introduced on the M I/O Aggregator.
Example
Dell#show monitor session
SessID Source Destination Dir Mode Source
IP Dest IP
------ ------ ----------- --- ----
--------- --------
1 Vl 10 Te 0/8 rx Flow N/
A N/A
Related
Commands
monitor session — creates a session for monitoring.
show running-config monitor session
Display the running configuration of all monitor sessions or a specific session.
Syntax
show running-config monitor session {session-ID}
To display the running configuration for all monitor sessions, use the show
running-config monitor session command.
Parameters
session-ID (OPTIONAL) Enter a session identification number. The range
from 0 to 65535.
Defaults none
Command
Modes
• EXEC
Port Monitoring
1047