Dell MXL 10GbE - Tunnel Destination

Defaults 0 (Mapped)
Command
Modes
INTERFACE TUNNEL (conf-if-tu)
Command
History
Version 9.3(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command configures the method used to set the high 6 bits (the differentiated
services codepoint) of the IPv4 TOS or the IPv6 traffic class in the outer IP header.
A value of 0 copies original packet DSCP (IPv4)/Traffic Class (IPv6) to the tunnel
header DSCP (IPv4)/Traffic Class (IPv6) depending on the mode of tunnel.
tunnel destination
Set a destination endpoint for the tunnel.
Syntax
tunnel destination {ip-address | ipv6–address}
To delete a tunnel destination address, use the no tunnel destination {ip-
address | ipv6–address} command.
Parameters
ip-address Enter the destination IPv4 address for the tunnel.
ipv6–address Enter the destination IPv6 address for the tunnel.
Defaults none
Command
Modes
INTERFACE TUNNEL (conf-if-tu)
Command
History
Version 9.3(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The tunnel interface is inoperable without a valid tunnel destination address for the
configured Tunnel mode.
To establish a logical tunnel to the particular destination address, use the
destination address of the outer tunnel header. If you configure a tunnel interface
or source address, the tunnel destination must be compatible.
1300
Tunneling