Dell MXL 10GbE - Excluded-Address

Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
excluded-address
Prevent the server from leasing an address or range of addresses in the pool.
Syntax
excluded-address [address | low-address high-address]
Parameters
address Enter a single address to be excluded from the pool.
low-address Enter the lowest address in a range of addresses to be
excluded from the pool.
high-address Enter the highest address in a range of addresses to be
excluded from the pool.
Defaults none
Command
Modes
DHCP
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
hardware-address
For manual configurations, specify the client hardware address.
Syntax
hardware-address address
Parameters
address Enter the hardware address of the client.
Defaults none
Command
Modes
DHCP <POOL>
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Dynamic Host Configuration Protocol (DHCP)
487