Dell MXL 10GbE - Ipv6 Ospf Dead-Interval

Using this formula, the default path cost is calculated as:
• GigabitEthernet—Default cost is 1
• TenGigabitEthernet—Default cost is 1
• FortygigEthernet — Default cost is 1
• Ethernet—Default cost is 10
ipv6 ospf dead-interval
Set the time interval since the last hello-packet was received from a router. After the time interval elapses,
the neighboring routers declare the router down.
Syntax
ipv6 ospf dead-interval seconds
Parameters
seconds
Enter the time interval in seconds. The range is from 1 to
65535 seconds.
Defaults 40 seconds (Ethernet).
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
By default, the dead interval is four times longer than the default ipv6 ospf
hello-interval
command.
ipv6 ospf encryption
Configure an IPsec encryption policy for OSPFv3 packets on an IPv6 interface.
Syntax
ipv6 ospf encryption {null | ipsec spi number esp encryption-
algorithm [key-encryption-type] key athentication-algorithm
[key-encryption-type] key}}
To remove an IPsec encryption policy from an interface, use the no ipv6 ospf
encryption spi number command.
To remove null authentication on an interface to allow the interface to inherit the
authentication policy configured for the OSPFv3 area, use the no ipv6 ospf
encryption null command.
992
Open Shortest Path First (OSPFv2 and OSPFv3)