Dell MXL 10GbE - Debug Ipv6 Ospf

debug ipv6 ospf
Display debug information and interface types on OSPF IPv6 packets or events.
Syntax
debug ipv6 ospf {packet | events} [interface]
Parameters
interface
(OPTIONAL) Enter one of the following keywords and slot/
port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Port Channel interface, enter the keyword port-
channel then a number. The range is 1 to 128.
• For a tunnel interface, enter the keyword tunnel then a
number. The range is 1 to 16383.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
default-information originate
Configure the system to generate a default external route into an OSPFv3 routing domain.
Syntax
default-information originate [always] [metric metric-value]
[metric-type type-value] [route-map map-name]
To return to the default values, use the no default-information originate
command.
Parameters
always (OPTIONAL) Enter the keyword always to specify that
default route information must always be advertised.
metric metric-
value
(OPTIONAL) Enter the keyword metric then a number to
configure a metric value for the route. The range is from 1 to
16777214.
metric-type
type-value
(OPTIONAL) Enter the keywords metric-type then an
OSPFv3 link state type of 1 or 2 for default routes. The values
are:
986
Open Shortest Path First (OSPFv2 and OSPFv3)