Defaults Not configured.
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The VRRP group only becomes active and sends VRRP packets when a link-local
virtual IP address is configured. When you delete the virtual address, the VRRP
group stops sending VRRP packets.
• When VRF microcode is not loaded in CAM, the VRID for a VRRP group is the
same as the VRID number configured with the vrrp-group or vrrp-ipv6-
group command.
• When VRF microcode is loaded in CAM, the VRID for a VRRP group is equal to
16 times the vrrp-group or vrrp-ipv6-group vrid number plus the ip
vrf vrf-id number. For example, if VRF microcode is loaded and VRRP group
10 is configured in VRF 2, the VRID used for the VRRP group is (16 x 10) + 2, or
162. This VRID value is used in the lowest byte of the virtual MAC address of the
VRRP group and is also used for VRF routing.
NOTE: Configure the same VRID on neighboring routers (Dell Networking OS
or non-Dell Networking OS) in the same VRRP group in order for all routers to
interoperate.
version
Set VRRP protocol version for IPv4 group.
Syntax
version {2 | 3 | both}
To return to the default setting, use the no version command.
Parameters
2 Enter the 2 parameter to specify VRRP version 2 as defined
by RFC 3768,
Virtual Router Redundancy Protocol.
3 Enter the 2 parameter to specify VRRP version 3 as defined
in RFC 5798, Virtual Router Redundancy.
both Enter the both keyword for in-service migration from VRRP
version 2 to VRRP version 3.
Defaults 2
Command
Modes
VRRP
Virtual Router Redundancy Protocol (VRRP)
1361
To Next Page
Loading...
