Dell MXL 10GbE - Ip Access-List Extended

ACL logging only on ACLs that are applied to ingress interfaces; you cannot enable
logging for ACLs that are associated with egress interfaces
Example
An ACL rule with a TCP port range of 4000–8000 uses eight entries in the CAM.
Dell# Data Mask From To #Covered
1 0000111110100000 1111111111100000 4000 4031 32
2 0000111111000000 1111111111000000 4032 4095 64
3 0001000000000000 1111100000000000 4096 6143 2048
4 0001100000000000 1111110000000000 6144 7167 1024
5 0001110000000000 1111111000000000 7168 7679 512
6 0001111000000000 1111111100000000 7680 7935 256
7 0001111100000000 1111111111000000 7936 7999 64
8 0001111101000000 1111111111111111 8000 8000 1
Total Ports: 4001
Example
An ACL rule with a TCP port lt 1023 uses only one entry in the CAM.
Dell# Data Mask From To #Covered
1 0000000000000000 1111110000000000 0 1023 1024
Total Ports: 1024
Related
Commands
deny — assigns a filter to deny IP traffic.
deny tcp — assigns a filter to deny TCP traffic.
ip access-list extended
Name (or select) an extended IP access list (IP ACL) based on IP addresses or protocols.
Syntax
ip access-list extended access-list-name
To delete an access list, use the no ip access-list extended access-
list-name
command.
Parameters
access-list-
name
Enter a string up to 140 characters long as the access list
name.
Defaults All access lists contain an implicit deny any; that is, if no match occurs, the packet
is dropped.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Access Control Lists (ACL)
165