Dell MXL 10GbE - Host

host
For manual (rather than automatic) configurations, assign a host to a single-address pool.
Syntax
host address
Parameters
address/mask Enter the host IP address and subnet mask.
Defaults none
Command
Modes
DHCP <POOL>
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
lease
Specify a lease time for the addresses in a pool.
Syntax
lease {days [hours] [minutes] | infinite}
Parameters
days Enter the number of days of the lease. The range is from 0 to
31.
hours Enter the number of hours of the lease. The range is from 0
to 23.
minutes Enter the number of minutes of the lease. The range is from
0 to 59.
infinite Specify that the lease never expires.
Defaults 24 hours
Command
Modes
DHCP <POOL>
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
netbios-name-server
Specify the NetBIOS windows internet naming service (WINS) name servers, in order of preference, that
are available to Microsoft dynamic host configuration protocol (DHCP) clients.
Syntax
netbios-name-server address [address2...address8]
488
Dynamic Host Configuration Protocol (DHCP)